TRENDnet TI-PG1284i User Manual page 140

TRENDnet User's Guide
if-range dhcp-snooping trust
if-range no dhcp-snooping
trust
Example:
TI-PG1284I#configure terminal
TI-PG1284I(config)#dhcp-snooping enable
TI-PG1284I(config)#dhcp-snooping vlan 1
TI-PG1284I(config)#interface 1/0/1
TI-PG1284I(config-if)#dhcp-snooping trust
Web Configuration
DHCP Snooping
Security > IP Source Guard > DHCP Snooping > DHCP Snooping
Parameter Description
Select Enable to use DHCP snooping on the Switch. You still
have to enable DHCP snooping on specific VLANs and specify
State trusted ports.
Note: The Switch will drop all DHCP requests if you enable
DHCP snooping and there are no trusted ports.
© Copyright 2016 TRENDnet. All Rights Reserved.
This command configures the trust port for
the specific ports.
This command configures the un-trust port
for the specific ports.
Select Disable to not use DHCP snooping.
Select Add and enter the VLAN IDs you want the Switch to
enable DHCP snooping on. You can designate multiple VLANs
individually by using a comma (,) and by range with a hyphen (-
VLAN State
).
Select Delete and enter the VLAN IDs you no longer want the
Switch to use DHCP snooping on.
Apply
Click Apply to take effect the settings.
Refresh
Click Refresh to begin configuring this screen afresh.
DHCP Snooping Status
DHCP Snooping
This field displays the current status of the DHCP snooping
State
feature, Enabled or Disabled.
This field displays the VLAN IDs that have DHCP snooping
Enabled on VLAN
enabled on them. This will display None if no VLANs have been
set.
TI-PG1284i
137