TRENDnet TI-PG1284i User Manual page 113

TRENDnet User's Guide
TI-PG1284I(config-ptp)#

Deleting Existing PTP Domain: This command is delete existing PTP domain from
domain list.
TI-PG1284I(config)#no ptp domain 1

Enabling PTP Domain: This command is used to enable PTP domain; by default PTP
domain is enabled.
TI-PG1284I(config-ptp)#domain enable

Disabling PTP Domain: This command is used to disable PTP domain.
TI-PG1284I(config-ptp)#no domain enable

Adding Clock Mode in PTP Domain: This command is used to add clock mode in
domain; by default domain is in forward clock mode.
TI-PG1284I(config-ptp)#clk-mode ordinary
TI-PG1284I(config-ptp)#clk-mode boundary
TI-PG1284I(config-ptp)#clk-mode transparent
TI-PG1284I(config-ptp)#clk-mode forward

Deleting Clock Mode from PTP Domain: This command is used to delete existing
clock mode from PTP domain and adds "Forward" mode as domain's clock mode.
TI-PG1284I(config-ptp)#no clk-mode
 st
Adding 1 Priority in PTP Domain: This command is used to add 1
st
domain; by default domain's 1
TI-PG1284I(config-ptp)#clk-priority1 20

st
Deleting 1 Priority from PTP Domain: This command is used to delete existing 1
priority from PTP domain and adds 128 as domain's first priority.
TI-PG1284I(config-ptp)#no clk-priority1
© Copyright 2016 TRENDnet. All Rights Reserved.
st
priority is 128.

Adding 2
domain; by default domain's 2
TI-PG1284I(config-ptp)#clk-priority2 30

Deleting 2
priority from PTP domain and adds domain's 2
TI-PG1284I(config-ptp)#no clk-priority2

Enabling Path Trace in PTP Domain: This command is used to enable path trace TLV
in PTP domain; by default path trace is disabled.
TI-PG1284I(config-ptp)#path-trace

Disabling Path Trace from PTP Domain: This command is used to disable path trace
from PTP domain.
TI-PG1284I(config-ptp)#no path-trace

Enabling Slave Mode in PTP Domain: This command is used to enable PTP domain as
slave only. In PTP network it will be act as member (slave). By default slave mode is
disabled in PTP domain.
TI-PG1284I(config-ptp)#slave

Disabling Slave Mode from PTP Domain: This command is used to disable slave mode
from PTP domain. PTP domain will be act as either Master or Member based on
received data sets by using BMC (Best Master Clock) algorithm.
TI-PG1284I(config-ptp)#no slave
priority in PTP

Enabling Two Step Clock in PTP Domain: This command is used to enable two step
clock mode in PTP domain; by default two step clock is disabled in domain.
TI-PG1284I(config-ptp)#two-step-clk
st

Disabling Two Step Clock from PTP Domain: This command is used to disable two
step clock mode from PTP domain.
TI-PG1284I(config-ptp)#no two-step-clk
nd
Priority in PTP Domain: This command is used to add 2
nd
priority is 128.
nd
Priority from PTP Domain: This command is used to delete existing 2
TI-PG1284i
nd
priority in PTP
nd
nd
priority as 128.
110