TRENDnet TI-PG1284i User Manual page 176

TRENDnet User's Guide
configure archive upload- This command uploads the current configurations
config <URL PATH> file to a TFTP server.
configure archive download- This command downloads a new copy of firmware
fw <URL PATH> file from TFTP / FTP / HTTP server.
Where <URL PATH> can be:
Example:
TI-PG1284I#configure terminal
TI-PG1284I(config)#interface eth0
TI-PG1284I(config-if)#ip address 172.20.1.101/24
TI-PG1284I(config-if)#ip address default-gateway 172.20.1.1
TI-PG1284I(config-if)#management vlan 1
Enable the DHCP client function for the switch.

TI-PG1284I#configure terminal

TI-PG1284I(config)#interface eth0

TI-PG1284I(config-if)#ip dhcp client enable
TI-PG1284I#show config-change-status
The user configuration file is default.
The configurations have been modified.
© Copyright 2016 TRENDnet. All Rights Reserved.
tftp://192.168.1.1/file
ftp://user:pass@192.168.1.1/file
http://192.168.1.1/file
tftp://192.168.1.1/file
Web Configuration
Management > Maintenance > Configuration
Save Configuration
Press the Save button to save the current settings to the NV-RAM (flash).
Upload / Download Configuration to /from a your server
Follow the steps below to save the configuration file to your PC.

Select the "Press "Download" to save configurations file to your PC".

Click the "Download" button to start the process.
Follow the steps below to load the configuration file from your PC to the Switch.

Select the "Upload configurations file to your Switch".

Select the full path to your configuration file.

Click the Upload button to start the process.
TI-PG1284i
173