Cli Command Modes - TRENDnet TI-PG1284i User Manual

TRENDnet User's Guide

CLI Command Modes

Node Command
enable show hostname
configure reboot
eth0 ip address A.B.C.D/M
interface show
acl show
vlan show
The Node type:

enable
Its command prompt is "TI-PG1284I#".
It means these commands can be executed in this command prompt.

configure
Its command prompt is "TI-PG1284I(config)#".
It means these commands can be executed in this command prompt.
In Enable code, executing command "configure terminal" enter the configure
node.
TI-PG1284I# configure terminal

eth0
Its command prompt is "TI-PG1284I(config-if)#".
It means these commands can be executed in this command prompt.
In Configure code, executing command "interface eth0" enter the eth0
interface node.
© Copyright 2016 TRENDnet. All Rights Reserved.
Description
This command displays the system's network
name.
This command reboots the system.
This command configures a static IP and subnet
mask for the system.
This command displays the current port
configurations.
This command displays the current access
control profile.
This command displays the current VLAN
configurations.
TI-PG1284I(config)#interface eth0
TI-PG1284I(config-if)#

interface
Its command prompt is "TI-PG1284I(config-if)#".
It means these commands can be executed in this command prompt.
In Configure code, executing command "interface gigaethernet1/0/5" enter
the interface port 5 node.
Or
In Configure code, executing command "interface fastethernet1/0/5" enter
the interface port 5 node.
Note: depend on your port speed, gigaethernet1/0/5 for gigabit Ethernet
ports and fastethernet1/0/5 for fast Ethernet ports.
TI-PG1284I(config)#interface gigaethernet1/0/5
TI-PG1284I(config-if)#

vlan
Its command prompt is "TI-PG1284I(config-vlan)#".
It means these commands can be executed in this command prompt.
In Configure code, executing command "vlan 2" enter the vlan 2 node.
Note: where the "2" is the vlan ID.
TI-PG1284I(config)#vlan 2
TI-PG1284I(config-vlan)#

acl
Its command prompt is "TI-PG1284I(config-acl)#".
It means these commands can be executed in this command prompt.
In Configure code, executing command "access-list test" enter the access-list
test node.
Note: where the "test" is the profile name.
TI-PG1284i
11