Cloud Settings; L3 Feature; Ipv4 Interface - TRENDnet TPE-30284 User Manual

TRENDnet User's Guide

Cloud Settings

System > Cloud Settings
This section allows you to setup your device for TRENDnet's Cloud Management (Hive).
With TRENDnet Hive, you will be able to manage and monitor your device through the
TRENDnet Cloud portal remotely.
1. Log into your switch management page (see "Access your switch management page"
on page 5).
2. Click on System, and then Cloud Settings.
3. Review the settings. When you have completed making changes, click Apply to save
the settings.
•
Cloud Mode: Select Enabled to connect the device to TRENDnet Hive, and
Disabled to disable connection.
•
Status: Displays the current connection status between the device and
TRENDnet Hive
•
Re-Register: Select Enabled to sync your device with your TRENDnet Hive
account, and Disabled to disable the sync.
•
Account: Enter your TRENDnet Hive account username
•
Password: Enter your TRENDnet Hive account password
Note: Connecting your device to the cloud will lock all configurations to be managed by
the cloud. To configure your device locally, please Disable your connection to the cloud.
© Copyright 2023 TRENDnet. All Rights Reserved.

L3 Feature

IPv4 Interface

System > L3 Feature > IPv4 Interface
This section allows you to change your switch IPv4 address settings and additionally
create and assign the aforementioned address to VLANs. Typically, the IP address
settings should be changed to match your existing network subnet in order to access the
switch management page on your network.
Default Switch IPv4 Address: 192.168.10.200
Default Switch IPv4 Subnet Mask: 255.255.255.0
1. Log into your switch management page (see "Access your switch management page"
on page 5).
2. Click on System, L3 Feature, and then IPv4 Interface.
3. To create a new entry per VLAN, type the VLAN number you would like to create,
then click Add. To view a specific VLAN ID's configuration, enter the VLAN ID into the
Interface VLAN field and then click Find.
4. To change the IPv4 IP address associated with a specific VLAN, click on Edit within the
lower table.
5. Review the settings. When you have completed making changes, click Apply to save
the settings.
•
Interface: Displays the VLAN that is currently being configured.
•
State: Select Enabled to enable this VLAN, and Disabled to disable this VLAN.
•
Get IP From: Select Static to statically assign an IP address and subnet mask,
select DHCP to automatically request one from your networks DHCP server.
PoE Web Smart Switch Series
14