Xpress Ring - TRENDnet TI-PG1284i User Manual

TRENDnet User's Guide
Current Bridge Status
Instance This is the MAC address of the current bridge.
MAC address This is the MAC address of the bridge.
Priority This is the priority of the Switch.

Xpress Ring

The Xpress-Ring is a fast-acting, self-healing ring recovery technology that enables
networks to recover from link failure within 10ms.
Fast Link Recovery and Ring Redundancy are important features for increasing the
reliability of non-stop systems.
If the network is planned correctly with an arbiter Switch and ring ports, the network will
recover from any segment failure within a very short time.
There are two roles (Forwarder and Arbiter) of the Switch in the Xpress-Ring. There is one
and only one Switch is the Arbiter Switch and the others are the forwarder Switch.
One of the ring ports of the Arbiter Switch will be set to blocking state. When one of the
ring connections is broken, the blocked port will be set to forwarding state.
Default Settings
Xpress-Ring Configurations:
The global Xpress Ring state is:Disabled.
Ring 1: State
Destination MAC : 01:80:c2:ff:ff:f0.
Role : Forwarder.
Primary Port : None.
© Copyright 2016 TRENDnet. All Rights Reserved.
: Disabled.
Secondary Port : None.
Ring 2: State : Disabled.
Destination MAC : 01:80:c2:ff:ff:f1.
Role : Forwarder.
Primary Port : None.
Secondary Port : None.
CLI Configuration
Node Command
enable show xpress-ring
configure xpress-ring
(disable|enable)
configure xpress-ring ring
(RING1|RING2) state
(disable|enable)
configure xpress-ring ring
(RING1|RING2) last-byte-
destination-mac VALUE
configure xpress-ring ring
(RING1|RING2) role
(forwarder|arbiter)
configure xpress-ring ring
(RING1|RING2) primary-
port PORTID
configure xpress-ring ring
(RING1|RING2)
secondary-port PORTID
TI-PG1284i
Description
This command displays the current Xpress-
Ring configurations.
This command enables/disables the Xpress-
Ring on the Switch.
This command enables/disables the ring on
the Switch.
This command configures the last byte of
the destination MAC for the ring on the
Switch.
This command configures the role
(forwarder/arbiter) for the ring on the
Switch.
This command configures the primary port
for the ring on the Switch.
Notice: If the global xpress ring is disabled
or ring state is disabled, you can input 0 to
reset the primary port.
This command configures the secondary
port for the ring on the Switch.
Notice: If the global xpress ring is disabled
or ring state is disabled, you can input 0 to
reset the primary port.
132