TRENDnet TI-PG1284i User Manual page 95

TRENDnet User's Guide
3 Enable 4 Enable
5 Enable 6 Enable
7 Enable 8 Enable
9 Enable 10 Enable
11 Enable 12 Enable
CLI Configuration
Node Command
enable show lldp This command displays the LLDP configurations.
enable show lldp neighbor This command displays all of the ports' neighbor
information.
configure lldp This command globally enables / disables the LLDP
(disable|enable) function on the Switch.
configure lldp tx-interval This command configures the interval to transmit
the LLDP packets.
configure lldp tx-hold This command configures the tx-hold time which
determines the TTL of the Switch's message.
(TTL=tx-hold * tx-interval)
interface lldp-agent This command configures the LLDP agent function.
(disable|enable|rx-
disable – Disable the LLDP on the specific port.
only|tx-only)
enable – Transmit and Receive the LLDP packet on
the specific port.
tx-only – Transmit the LLDP packet on the specific
port only.
rx-only – Receive the LLDP packet on the specific
port.
configure interface range This command enters the interface configure
gigabitethernet1/0/ node.
PORTLISTS
© Copyright 2016 TRENDnet. All Rights Reserved.
Description
if-range lldp-agent This command configures the LLDP agent function.
(disable|enable|rx-
disable – Disable the LLDP on the specific port.
only|tx-only)
enable – Transmit and Receive the LLDP packet on
the specific port.
tx-only – Transmit the LLDP packet on the specific
port only.
rx-only – Receive the LLDP packet on the specific
port.
TI-PG1284i
92