Basic Settings; General Settings; System - TRENDnet TI-PG1284i User Manual

TRENDnet User's Guide
This field displays whether the DHCP client is enabled on the
DHCP Client
Switch.
IP Address
This field indicates the IP address of the Switch.
Subnet Mask
This field indicates the subnet mask of the Switch.
Default Gateway
This field indicates the default gateway of the Switch.
This field displays the MAC (Media Access Control) address of the
MAC Address
Switch.
The serial number assigned by manufacture for identification of
Serial Number
the unit.
Management
This field displays the VLAN ID that is used for the Switch
VLAN
management purposes.
CPU Loading
This field displays the percentage of your Switch's system load.
Memory
This field displays the total memory the Switch has and the
Information
memory which is currently available (Free) and occupied (Usage).
This field displays current date (yyyy-mm-dd) and time
Current Time
(hh:mm:ss).
This field displays whether the DHCPv6 client is enabled on the
DHCPv6 Client
Switch.
IPv6 Link Local
This field displays the Switch's link local IP address for IPv6.
IPv6 Default
This field displays the default gateway for IPv6.
Gateway
IPv6 Global
This field displays the Switch's global IP address for IPv6.
Refresh
Click this to update the information in this screen.
© Copyright 2016 TRENDnet. All Rights Reserved.

Basic Settings

General Settings

System

Management VLAN
To specify a VLAN group which can access the Switch.

The valid VLAN range is from 1 to 4094.

If you want to configure a management VLAN, the management VLAN should
be created first and the management VLAN should have at least one member
port.
Host Name
The hostname is same as the SNMP system name. Its length is up to 64 characters.
The first 16 characters of the hostname will be configured as the CLI prompt.
Default Settings
The default Hostname is TI-PG1284I
The default DHCP client is disabled.
The default Static IP is 192.168.10.200
Subnet Mask is 255.255.255.0
Default Gateway is 0.0.0.0
Management VLAN is 1.
CLI Commands
Node Command
enable ping IPADDR [–c COUNT]
TI-PG1284i
Description
This command
sends an echo
request to the
destination host.
The –c parameter
allow user to
specific the packet
14