TRENDnet TI-PG1284i User Manual page 114

TRENDnet User's Guide

Creating PTP Port in Domain: This command is used to create PTP port in domain
with default values and it provides us "config-ptp-port" command prompt.
TI-PG1284I(config-ptp)#port 1
TI-PG1284I(config-ptp-port)#

Deleting PTP Port from Domain: This command is used to delete PTP port from
Domain.
TI-PG1284I(config-ptp)#no port 1

Enabling PTP Port: This command is used to enable PTP port; by default PTP port is
disabled.
TI-PG1284I(config-ptp-port)#port enable

Disabling PTP Port: This command is used to disable PTP port.
TI-PG1284I(config-ptp-port)#no port enable

Enabling Acceptable Master in PTP Port: This command is used to enable acceptable
master mode in PTP port; by default it is disabled.
TI-PG1284I(config-ptp-port)#acceptable-master enable

Disabling Acceptable Master in PTP port: This command is used to disable acceptable
maser mode in PTP port.
TI-PG1284I(config-ptp-port)#no acceptable-master enable

Adding Announce Interval in PTP port: This command is used to add announce
interval in PTP port; by default announce interval value in PTP port is 1
TI-PG1284I(config-ptp-port)#announce interval 2

Deleting Announce Interval from PTP Port: This command is used to delete existing
announce interval from PTP port and adds 1 (default value) as announce interval in
PTP port.
TI-PG1284I(config-ptp-port)#no announce interval
© Copyright 2016 TRENDnet. All Rights Reserved.

Adding Announce Timeout in PTP Port: This command is used to add specified value
as announce timeout in PTP port; by default announce timeout value is 3.
TI-PG1284I(config-ptp-port)#announce timeout 3

Deleting Announce Timeout from PTP Port: This command is used to delete existing
announce timeout value from PTP port and adds 3 (default value) as announce
timeout in PTP port.
TI-PG1284I(config-ptp-port)#no announce timeout

Adding Synchronous Interval in PTP Port: This command is used to add specified
value synchronous interval in PTP port; by default synchronous interval is 0.
TI-PG1284I(config-ptp-port)#sync interval 1

Deleting Synchronous Interval from PTP Port: This command is used to delete
existing synchronous interval from PTP port and adds 0 (default value) as
synchronous interval.
TI-PG1284I(config-ptp-port)#no sync interval

Adding VLAN List into PTP Port: This command is used to add specified VLAN list into
PTP port; by default there is no VLAN list in PTP port.
TI-PG1284I(config-ptp-port)#vlan 1-10

Deleting VLAN List from PTP Port: This command is used to delete specified VLAN
list from PTP port.
TI-PG1284I(config-ptp-port)#no vlan 5-6

Displays All PTP Configurations: This command is used to display all existing PTP
configurations.
TI-PG1284I#show ptp information
PTP Status : Disable
PTP Primary Domain : 0(Default)
TI-PG1284i
111