Stp - TRENDnet TI-PG1284i User Manual

TRENDnet User's Guide
Adds a static IPv4 ARP entry in the ARP table.
IPv4 ARP Table
/ Deletes a static IPv4 ARP entry from the ARP table.
IP: The IP address for the entry.
MAC: The MAC address for the entry.
Adds a static IPv6 ARP entry in the ARP table.
IPv6 ARP Table
/ Deletes a static IPv6 ARP entry from the ARP table.
IP: The IP address for the entry.
MAC: The MAC address for the entry.
Route Settings
vlan Specifics an interface vlan.
Adds an IPv4 Interface Route / Static Route onto the interface
vlan. / Deletes an IPv4 Interface Route / Static Route from the
IPv4
interface vlan.
Selects the route type, Interface Route or Static Route.
IP/M: The IP address and the netmask for the entry.
IP: The static route address for the Static Route type only.
Adds an IPv6 Interface Route / Static Route onto the interface
vlan. / Deletes an IPv6 Interface Route / Static Route from the
IPv6
interface vlan.
Selects the route type, Interface Route or Static Route.
IP/M: The IP address and the netmask for the entry.
IP: The static route address for the Static Route type only.
© Copyright 2016 TRENDnet. All Rights Reserved.
Status
Shows the ARP table / Host table / Route configurations.

STP

STP/RSTP
(R)STP detects and breaks network loops and provides backup links between switches,
bridges or routers. It allows a Switch to interact with other (R)STP compliant switches in
your network to ensure that only one path exists between any two stations on the
network.
The Switch supports Spanning Tree Protocol (STP) and Rapid Spanning Tree Protocol
(RSTP) as defined in the following standards.

IEEE 802.1D Spanning Tree Protocol

IEEE 802.1w Rapid Spanning Tree Protocol
The Switch uses IEEE 802.1w RSTP (Rapid Spanning Tree Protocol) that allows faster
convergence of the spanning tree than STP (while also being backwards compatible with
STP-only aware bridges). In RSTP, topology change information is directly propagated
throughout the network from the device that generates the topology change. In STP, a
longer delay is required as the device that causes a topology change first notifies the root
bridge and then the root bridge notifies the network. Both RSTP and STP flush unwanted
learned addresses from the filtering database.
In STP, the port states are Blocking, Listening, Learning, Forwarding.
In RSTP, the port states are Discarding, Learning, and Forwarding.
Note: In this document, "STP" refers to both STP and RSTP.
STP Terminology

The root bridge is the base of the spanning tree.

Path cost is the cost of transmitting a frame onto a LAN through that port. The
recommended cost is assigned according to the speed of the link to which a
TI-PG1284i
118