TRENDnet TI-PG1284i User Manual page 93

TRENDnet User's Guide
if-range lacp port_priority <1-
65535>
if-range no lacp port_priority
Web Configuration
LACP Settings
Advanced Settings > Link Aggregation > LACP
Parameter Description
Select Enable from the drop down box to enable Link Aggregation
Control Protocol (LACP).
State
Select Disable to not use LACP.
© Copyright 2016 TRENDnet. All Rights Reserved.
This command configures the priority for the
specific ports.
Note: The default value is 32768.
This command configures the default for the
priority for the specific ports.
LACP system priority is a number between 1 and 65,535. The switch
with the lowest system priority (and lowest port number if system
priority is the same) becomes the LACP "server". The LACP "server"
System Priority
controls the operation of LACP setup. Enter a number to set the
priority of an active port using Link Aggregation Control Protocol
(LACP). The smaller the number, the higher the priority level.
Select a trunk group ID and then select whether to Enable or Disable
Group LACP
Group Link Aggregation Control Protocol for that trunk group.
Port Priority Select a port or a range of ports to configure its (their) LACP priority.
Apply Click Apply to configure the settings.
Refresh Click this to reset the fields to the last setting.
LACP Group Status
Group ID The field identifies the LACP group ID.
LACP State This field displays if the group has LACP enabled.
LACP Port Priority Status
Port The field identifies the port ID.
Priority The field identifies the port's LACP priority.
TI-PG1284i
90