Sfp Information; Traffic Monitor - TRENDnet TI-PG1284i User Manual

TRENDnet User's Guide

SFP Information

The SFP information allows user to know the SFP module's information, such as vendor
name, connector type, revision, serial number, manufacture date, and to know the DDMI
information if the SFP modules have supported the DDMI function.
CLI Configuration
Node Command
enable show sfp info port
PORT_ID
enable show sfp ddmi port
PORT_ID
Web Configuration
Monitor > SFP Information
Parameter Description
Port Select a port number to configure.
Apply Click Apply to display the SFP information.
Fiber Cable To indicate if the fiber cable is connected.
Connector Code of optical connector type.
© Copyright 2016 TRENDnet. All Rights Reserved.
Description
This command displays the SFP
information.
This command displays the SFP DDMI
status.
Vendor Name SFP vendor name.
Vendor PN Part Number.
Vendor rev Revision level for part number.
Vendor SN Serial number (ASCII).
Date Code Manufacturing date code.
Notice: If the fiber cable is not connected, the Rx Power fields are not available.

Traffic Monitor

The function can be enabled / disabled on a specific port or globally be enabled disabled
on the Switch.
The function will monitor the broadcast / multicast / broadcast and multicast packets
rate. If the packet rate is over the user's specification, the port will be blocked. And if the
recovery function is enabled, the port will be enabled after recovery time.
Default Settings
Packet Packet
Port State Status Type
---- -------- ------- ----------- --------- -------- ---------
1 Disabled Normal Bcast
2 Disabled Normal Bcast
3 Disabled Normal Bcast
4 Disabled Normal Bcast
5 Disabled Normal Bcast
6 Disabled Normal Bcast
7 Disabled Normal Bcast
8 Disabled Normal Bcast
9 Disabled Normal Bcast
10 Disabled Normal Bcast
TI-PG1284i
Recovery
Rate(pps) State Time(min)
1000 Enabled 1
1000 Enabled 1
1000 Enabled 1
1000 Enabled 1
1000 Enabled 1
1000 Enabled 1
1000 Enabled 1
1000 Enabled 1
1000 Enabled 1
1000 Enabled 1
161