Dhcp Pool; Dhcp Relay; Dhcp Relay General Settings - TRENDnet TPE-30102WS User Manual

TRENDnet User's Guide

DHCP Pool

DHCP > DHCP Server > Pool
1. Log into your switch management page (see
on page 11).
2. Click on DHCP, then click on DHCP Server, and click on Pool.
3. Review the settings. Click Add to add the database entry to the table.

Pool Name: This is used to identify the pool name. The identifier is limited to
16 characters.

IP Address: Enter the IP address of the DHCP Pool.

Subnet Mast: Enter the subnet Mask

Default Gateway: Enter the IP Address of your default gateway.

DNS Server: Enter the IP address of your DNS server

Lease Time: Enter the lease time in days, hours, and minutes.
In the list, you can click Modify to modify an entry or click Delete or delete the entry.
You can also click Delete All to delete all of the entries in the table. If the entries span
multiple pages, you can navigate page number in the Page field and click Go or you can
click First, Previous, Next, and Last Page to navigate the pages.
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access your switch management page"
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.

DHCP Relay

A DHCP (Dynamic Host Configuration) Relay allows any host to forward DHCP packets
between clients and servers. This allows agents to forward requests and replies
between clients and servers when they are not on the same subnet.

DHCP Relay General Settings

DHCP > DHCP Relay > General Settings
1. Log into your switch management page (see
on page 11).
2. Click on DHCP, then click on DHCP Relay, and click on General Settings.
3. Review the settings. Click Apply to save the settings.

DHCP Relay – Click on Enabled or Disabled to turn on or turn off DHCP Relay.

Relay Server Address – Input the IP address of the Relay Server.

Option 82 – Select one of the following choices the menu.
o
Enabled – Allows an Option 82 packet to be passed through the switch
without being altered
o
Disabled – Blocks an Option 82 packet from passing through the
switch

Option 82 Policy – Select one of the following choices from the menu
TPE-30102WS
"Access your switch management page"
89