TRENDnet TI-PG1284i User Manual page 165

TRENDnet User's Guide
11 Disabled Normal Bcast
12 Disabled Normal Bcast
CLI Configuration
Node Command
enable show traffic-monitor
configure traffic-monitor
(disable|enable)
interface traffic-monitor
(disable|enable)
interface traffic-monitor rate
RATE_LIMIT type
(bcast|mcast|bcast+mcast)
interface traffic-monitor recovery
(disable|enable)
interface traffic-monitor recovery
time VALUE
configure interface range
gigabitethernet1/0/
PORTLISTS
if-range traffic-monitor
(disable|enable)
if-range traffic-monitor rate
RATE_LIMIT type
(bcast|mcast|bcast+mcast)
© Copyright 2016 TRENDnet. All Rights Reserved.
1000 Enabled 1
1000 Enabled 1
Description
This command displays the traffic monitor
configurations and current status.
This command enables / disables the traffic
monitor on the Switch.
This command enables / disables the traffic
monitor on the port.
This command configures the packet rate
and packet type for the traffic monitor on
the port.
bcast – Broadcast packet.
mcast – Multicast packet.
This command enables / disables the
recovery function for the traffic monitor on
the port.
This command configures the recovery
time for the traffic monitor on the port.
This command enters the interface
configure node.
This command enables / disables the traffic
monitor on the port.
This command configures the packet rate
and packet type for the traffic monitor on
the port.
bcast – Broadcast packet.
mcast – Multicast packet.
if-range traffic-monitor recovery
(disable|enable)
if-range traffic-monitor recovery
time VALUE
Web Configuration
Monitor > Traffic Monitor
Parameter Description
State Globally enables / disables the traffic monitor function.
Port The port range which you want to configure.
State Enables / disables the traffic monitor function on these ports.
TI-PG1284i
This command enables / disables the
recovery function for the traffic monitor on
the port.
This command configures the recovery
time for the traffic monitor on the port.
162