TRENDnet TI-PG1284i User Manual page 18

TRENDnet User's Guide
enable ping IPADDR [–s SIZE]
enable ping IPADDR [–c COUNT –s SIZE]
enable ping IPADDR [-s SIZE –c COUNT]
© Copyright 2016 TRENDnet. All Rights Reserved.
count. The default
count is 4.
This command configure
sends an echo
request to the
destination host.
configure
The –s parameter
allow user to
specific the packet
size. Valid range: 0 configure
~ 1047 bytes.
This command
sends an echo
request to the
destination host.
configure
The –c parameter
allow user to
specific the packet
configure
count. The default
count is 4. The –s
parameter allow
user to specific the
eth0
packet size. Valid
range: 0 ~ 1047
bytes.
eth0
This command
sends an echo
request to the
destination host.
The –c parameter
eth0
allow user to
specific the packet
count. The default
count is 4. The –s
parameter allow
eth0
user to specific the
packet size. Valid
reboot
hostname STRINGS
interface eth0
configure terminal
interface eth0
show
ip address A.B.C.D/M
ip address default-gateway A.B.C.D
ip dhcp client (disable|enable|renew)
TI-PG1284i
range: 0 ~ 1047
bytes.
This command
reboots the
system.
This command sets
the system's
network name.
This command
enters the eth0
interface node to
configure the
system IP.
This command
changes the mode
to config mode.
This command
changes the mode
to eth0 mode.
This command
displays the eth0
configurations.
This command
configures a static
IP and subnet
mask for the
system.
This command
configures the
system default
gateway.
This command
configures a DHCP
15