TRENDnet TI-PG1284i User Manual page 46

TRENDnet User's Guide
configure igmp-snooping report-
suppression
(disable|enable)
configure clear igmp-counters
configure clear igmp-counters
(port|vlan)
interface igmp-querier-mode
(auto|fixed|edge)
interface igmp-immediate-leave
interface no igmp-immediate-
leave
interface igmp-snooping group-
limit VALUE
interface no igmp-snooping
group-limit
configure interface range
gigabitethernet1/0/
PORTLISTS
if-range igmp-immediate-leave
© Copyright 2016 TRENDnet. All Rights Reserved.
This command disables / enables the IGMP
snooping report suppression function on the
switch.
This command clears the IGMP snooping
counters.
This command clears the IGMP snooping
counters for port or vlan.
This command specifies whether or not and
under what conditions the port(s) is (are)
IGMP query port(s). The Switch forwards
IGMP join or leave packets to an IGMP query
port, treating the port as being connected to
an IGMP multicast router (or server). You
must enable IGMP snooping as well.
(Default:auto)
This command enables the IGMP Snooping
immediate leave function for the specific
interface.
This command disables the IGMP Snooping
immediate leave function for the specific
interface.
This command configures the maximum
groups for the specific interface.
This command removes the limitation of the
maximum groups for the specific interface.
This command enters the interface configure
node.
This command enables the IGMP Snooping
immediate leave function for the specific
ports.
if-range no igmp-immediate-
leave
if-range igmp-snooping group-
limit VALUE
if-range no igmp-snooping
group-limit
if-range igmp-querier-mode
(auto|fixed|edge)
Example:
TI-PG1284I(config)#igmp-snooping enable
TI-PG1284I(config)#igmp-snooping vlan 1
TI-PG1284I(config)#igmp-snooping querier enable
TI-PG1284I(config)#igmp-snooping querier vlan 1
TI-PG1284I(config)#interface 1/0/1
TI-PG1284I(config-if)#igmp-immediate-leave
TI-PG1284I(config-if)#igmp-querier-mode fixed
TI-PG1284I(config-if)#igmp-snooping group-limit 20
TI-PG1284i
This command disables the IGMP Snooping
immediate leave function for the specific
ports.
This command configures the maximum
groups for the specific ports.
This command removes the limitation of the
maximum groups for the specific ports.
This command specifies whether or not and
under what conditions the ports is (are) IGMP
query port(s). The Switch forwards IGMP join
or leave packets to an IGMP query port,
treating the port as being connected to an
IGMP multicast router (or server). You must
enable IGMP snooping as well. (Default:auto)
43