Table of Contents
Advertisement
TRENDnet User's Guide
interface
loop-detection recovery
time VALUE
configure
interface range
gigabitethernet1/0/
PORTLISTS
if-range
loop-detection (disable |
enable)
if-range
loop-detection recovery
(disable | enable)
if-range
loop-detection recovery
time VALUE
Example:
TI-PG1284I(config)#loop-detection enable
TI-PG1284I(config)#interface 1/0/1
TI-PG1284I(config-if)#loop-detection enable
© Copyright 2016 TRENDnet. All Rights Reserved.
This command configures the recovery
period time.
This command enters the interface
configure node.
This command disables / enables the loop
detection on the ports.
This command enables / disables the
recovery function on the port.
This command configures the recovery
period time.
Web Configuration
Advanced Settings > Loop Detection
Parameter
Description
State
Select this option to enable loop guard on the Switch.
Enter the destination MAC address the probe packets will be sent
MAC Address
to. If the port receives these same packets the port will be shut
down.
Port
Select a port on which to configure loop guard protection.
State
Select Enable to use the loop guard feature on the Switch.
Select Enable to reactivate the port automatically after the
Loop Recovery
designated recovery time has passed.
Specify the recovery time in minutes that the Switch will wait
Recovery Time
before reactivating the port. This can be between 1 to 60 minutes.
TI-PG1284i
95
Hide quick links:
Advertisement
Table of Contents
