Management; Snmp - TRENDnet TI-PG1284i User Manual

TRENDnet User's Guide
Action Unblock these ports.
Packet Type Specify the packet type which you want to monitor.
Packet Rate Specify the packet rate which you want to monitor.
Enables / disables the recovery function for the traffic monitor
Recover State
function on these ports.
Configures the recovery time for the traffic monitor function on
Recovery Time
these ports.(Range: 1 – 60 minutes)
© Copyright 2016 TRENDnet. All Rights Reserved.

Management

SNMP

Simple Network Management Protocol (SNMP) is used in network management systems
to monitor network-attached devices for conditions that warrant administrative
attention. SNMP is a component of the Internet Protocol Suite as defined by the Internet
Engineering Task Force (IETF). It consists of a set of standards for network management,
including an application layer protocol, a database schema, and a set of data objects.
SNMP exposes management data in the form of variables on the managed systems, which
describe the system configuration. These variables can then be queried (and sometimes
set) by managing applications.
Support below MIBs:

RFC 1157 A Simple Network Management Protocol

RFC 1213 MIB-II

RFC 1493 Bridge MIB

RFC 1643 Ethernet Interface MIB

RFC 1757 RMON Group 1,2,3,9
SNMP community act like passwords and are used to define the security parameters of
SNMP clients in an SNMP v1 and SNMP v2c environments. The default SNMP community
is "public" for both SNMP v1 and SNMP v2c before SNMP v3 is enabled. Once SNMP v3 is
enabled, the communities of SNMP v1 and v2c have to be unique and cannot be shared.
Network ID of Trusted Host:
The IP address is a combination of the Network ID and the Host ID.
Network ID = (Host IP & Mask).
User need only input the network ID and leave the host ID to 0. If user has
input the host ID, such as 192.168.1.102, the system will reset the host ID,
such as 192.168.1.0
Note: Allow user to configure the community string and rights only.
TI-PG1284i
163