Table of Contents
Advertisement
TRENDnet User's Guide
4. At the right hand panel, click the check mark to save your settings.
5. At the top right of the screen, click Apply.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
Jumbo Frames
Network > Physical Interface > Jumbo Frames
The jumbo frame setting is applied globally on all ports and cannot be configured
independently on each individual port. By default the jumbo frame setting is configured
1522 bytes.
This section lets you input the size of the Jumbo Frames that can be accepted by the
switch.
1. Log into your switch management page (see
on page 9).
2. Click on Network, then click on Physical Interface, and click on Jumbo Frames.
3. Enter the size of the Jumbo Frames to be accepted by the switch (in Bytes).
© Copyright 2023 TRENDnet. All Rights Reserved.
"Access your switch management
page"
Note: The value of the Jumbo Frames needs to be between 1522 and 10240 Bytes. By
default the value is 1522 Bytes.
4. Click Reset to reset the size of the Jumbo Frames to its default value. To save your
new Jumbo Frame size, click Apply.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
TL2-F7120
33
Advertisement
Table of Contents
