Configuring Forwarding Plane Parameters - Alcatel-Lucent 7750 Configuration Manual

Configuring Forwarding Plane Parameters

The following output provides a forwarding plane configuration. The fp command is not allowed
on iom-1 or iom-2 types. An error message appears when the command is executed on an
incorrect IOM type:
*A:Dut-C# configure card 10
*A:Dut-C>config>card# info
----------------------------------------------
----------------------------------------------
*A:Dut-C>config>card# exit
7750 SR Interface Configuration Guide
MINOR: CLI This command is not supported for iom2-20g.
card-type iom3-xp
fp 1
ingress
mcast-path-management
bandwidth-policy "BWP"
no shutdown
exit
exit
exit
mda 1
mda-type m1-10gb
ingress
mcast-path-management
bandwidth-policy "BWP"
no shutdown
exit
exit
exit
mda 2
mda-type m2-10gb-xfp
ingress
mcast-path-management
bandwidth-policy "BWP"
no shutdown
exit
exit
exit
Interface Configuration
Page 189