Alcatel-Lucent 7750 Configuration Manual page 643

MTU
Admin State
Oper State
Duplex
Hold time up
Hold time down
Reset On Path
Down
Physical Link
IfIndex
Last State chg
Last State
Change
Phys State Chng
Cnt
Last Cleared
Time
7750 SR Interface Configuration Guide
Label
The size of the largest packet which can be sent/received on the Ethernet
physical interface, specified in octets.
Up — The port is administratively up.
Down — The port is administratively down.
Up — The port is operationally up.
Down — The port is operationally down.
Additionally, the lag-id of the LAG it belongs to in addition to the status of
the LAG member (active or standby) is specified.
Full — The link is set to full duplex mode.
Half — The link is set to half duplex mode.
The link up dampening time in seconds. The port link dampening timer
value which reduces the number of link transitions reported to upper layer
protocols.
The link down dampening time in seconds. The down timer controls the
dampening timer for link down transitions.
Whether a SONET/SDH port will reset when the path transitions to an
operationally down state. Only SONET/SDH ports on 7750 4-port OC48
SFP "-B" MDAs will reset if Reset On Path Down is enabled.
Yes — A physical link is present.
— A physical link is not present.
No
Displays the interface's index number which reflects its initialization
sequence.
Displays the system time moment that the peer is up.
Displays the system time moment that the MC-LAG group is up.
Increments when a fully qualified (de-bounced) transition occurs at the
physical layer of an ethernet port which includes the following transitions of
the Port State as shown in the "show port" summary:
- from "Down" to either "Link Up" or "Up"
- from either "Link Up" or "Up" to "Down"
This counter does not increment for changes purely in the link protocol
states (e.g. "Link Up" to "Up"). The counter is reset if the container objects
for the port are deleted (e.g. MDA deconfigured, or IOM type changes).
Displays the system time moment that the peer is up.
Interface Configuration
Description (Continued)
Page 643