Alcatel-Lucent 7750 Configuration Manual page 462

Interfaces
Default none
Parameters sts3 — Configures STS3/STM1 payload as clear channel.
tu3 — Configures STS3/STM1 payload as Tributary Unit Group 3 (TUG3).
ds3 — Configures the port or channel as DS-3 STS1/VC3 payload as DS-3.
e3 — Configures the port or channel as E-3 STS1/VC3 payload as E-3.
vt2 — Configures the path STS1 payload as vt2 as a virtual tributary group. Only allowed on STS-1 nodes.
(SONET VT container)
vt15 — Configures the path as a virtual tributary group. Only allowed on STS-1 nodes. (SONET VT con-
tainer)
ds1 — Configures the port or channel as DS1.vt15 or vt2 payload as DS-1
e1 — Configures VT2 payload as E-1.
report-alarm
Syntax [no] report-alarms [pais] [plop] [prdi] [pplm] [prei] [puneq] [plcd]
Context config>port>sonet-sdh>path
Description
This command enables logging of SONET (SDH) path alarms for a SONET-SDH port. Only path alarms can
be configured in the channel context.
The no form of this command disables logging of the specified alarms.
Parameters pais — Reports path alarm indication signal errors. When configured, pais alarms are raised and cleared.
Default
plop — Reports path loss of pointer (per tributary) errors. When configured, plop traps are raised but not
cleared.
Default
prdi — Reports path remote defect indication errors. When configured, prdi alarms are raised and cleared.
Default
pplm — Reports a path payload mismatch, as a result the channel will be operationally downed. When con-
figured, pplm traps are raised but not cleared.
Default
prei — Reports a path error condition raised by the remote as a result of b3 errors received from this node.
When configured, prei traps are raised but not cleared.
Default
puneq — Reports path unequipped errors. Reports path unequipped signal errors.
Default
plcd — Reports path loss of codegroup delineation errors. It is applicable only when the value of xgig is set
Page 462
pais alarms are not issued
plop traps are issued
prdi alarms are not issued
pplm traps are issued
prei traps are not issued
puneq traps are issued
7750 SR Interface Configuration Guide