Alcatel-Lucent 7750 Configuration Manual page 396

Interfaces
The no form of this command reverts the dot1q-etype value to the default.
Parameters 0x0600..0xffff — Specifies the Ethertype to expect.
Default
duplex
Syntax duplex {full | half}
Context config>port>ethernet
Description This command configures the duplex of a Fast Ethernet port when autonegotiation is disabled.
This configuration command allows for the configuration of the duplex mode of a Fast Ethernet port. If the
port is configured to autonegotiate this parameter is ignored.
Default
full
Parameters
full — Sets the link to full duplex mode.
half — Sets the link to half duplex mode.
efm-oam
Syntax efm-oam
Context config>port>ethernet
Description This command configures EFM-OAM attributes.
accept-remote-loopback
Syntax [no] accept-remote-loopback
Context config>port>ethernet>efm-oam
Description This command enables reactions to loopback control OAM PDUs from peers.
The no form of this command disables reactions to loopback control OAM PDUs.
Default no accept-remote-loopback
discovery
Syntax discovery
Page 396
If the encap-type is dot1p, then the default is 0x8100.
If the encap-type is qinq, then the default is 0x8100.
7750 SR Interface Configuration Guide