Alcatel-Lucent 7750 Configuration Manual page 526

Interfaces
ETH-CFM Configuration Commands
eth-cfm
Syntax eth-cfm
Context config>port>ethernet
config>lag
Description This command enables the context to configure 802.1ag CFM parameters.
mep
Syntax mep mep-id domain md-index association ma-index [vlan vlan-id]
no mep mep-id domain md-index association ma-index [vlan vlan-id]
Context config>port>ethernet>eth-cfm
config>lag>eth-cfm
config>router>if>eth-cfm
Description This command provisions the maintenance endpoint (MEP).
The no form of the command reverts to the default values.
Parameters mep-id — Specifies the maintenance association end point identifier.
Values
md-index — Specifies the maintenance domain (MD) index value.
Values
ma-index — Specifies the MA index value.
Values
vlan-id — Specific to tunnel facility MEPs which means this option is only applicable to the lag>eth-
cfm> context. Used to specify the outer vlan id of the tunnel.
Values
ais-enable
Syntax [no] ais-enable
Context config>port>ethernet>eth-cfm>mep
config>lag>eth-cfm>mep
Page 526
1 — 81921
1 — 4294967295
1 — 4294967295
1 — 4094
7750 SR Interface Configuration Guide