Alcatel-Lucent 7750 Configuration Manual page 579

purposes. From the policer's perspective, the maximum packet size is increased by the amount being
added to the size of each packet.
Values
Default
subtract bytes — The subtract keyword is mutually exclusive to the add keyword. Either add or subtract
must be specified. When b is defined the corresponding bytes parameter specifies the number of bytes
that is subtracted from the size of each packet associated with the policer for rate metering, profiling and
accounting purposes. From the policer's perspective, the maximum packet size is reduced by the
amount being subtracted from the size of each packet. Note that the minimum resulting packet size used
by the system is 1 byte.
Values
Default
mcast-path-management
Syntax mcast-path-management
Context config>card>fp>ingress
config>card>mda>ingress
Description This CLI node contains the forwarding plane or MDA settings for ingress multicast path management. Enter
the node to configure the bandwidth-policy, the individual path bandwidth overrides and the administrative
state of ingress multicast path management.
bandwidth-policy
Syntax bandwidth-policy policy-name
no bandwidth-policy
Context config>card>fp>ingress>mcast-path-management
config>card>mda>ingress>mcast-path-management
Description
This command is used to explicitly associate a bandwidth policy to a forwarding plane or MDA. The band-
width policy defines the dynamic rate table and the multicast paths bandwidth and queuing parameters.
If a bandwidth policy is not explicitly associated with a forwarding plane or MDA, the default bandwidth
policy is used when ingress multicast path management is enabled.
The no form of the command removes an explicit bandwidth policy from a forwarding plane or MDA and
restores the default bandwidth policy.
Parameters policy-name — The policy-name parameter is required and defines the bandwidth policy that should be
associated with the MDA or forwarding plane for ingress multicast path management. If the policy
name does not exist, the bandwidth-policy command will fail.
Values
7750 SR Interface Configuration Guide
1 — 31
None
0—64
None
Any existing bandwidth policy name
Interface Configuration
Page 579