Alcatel-Lucent 7750 Configuration Manual page 491

framing (E-3)
Syntax framing {g751 | g832 | unframed-e3}
Context config>port>tdm>e3
Description
This command specifies E-3 framing for the associated E-3 port or channel.
Default E-3 non-ATM:
E-3 ATM:
Parameters
g751 — Configures the E-3 port/channel for g751 framing.
g832 — Configures the E-3 port/channel for g832 framing.
unframed-e3 — Specifies e-3 unframed mode for E-3 interfaces. This parameter allows the configuration
of an unstructured E-3 channel on a CES MDA.
idle-cycle-flag
Syntax idle-cycle-flag {flags | ones}
Context config>port>tdm>ds1>channel-group
config>port>tdm>ds3
config>port>tdm>e1
config>port>tdm>e1>channel-group
config>port>tdm>e3
Description This command configures the value that the HDLC TDM DS-0, E-1, E-3, DS-1, or DS-3 interface transmits
during idle cycles. For ATM ports/channels/channel-groups, the configuration does not apply and only the
no form is accepted.
The no form of this command reverts the idle cycle flag to the default value.
Default flags (0x7E)
no flags (ATM)
Parameters flags — Specifies that 0x7E is used as the idle cycle flag.
ones — Specifies that 0xFF is used as the idle cycle flag.
idle-payload-fill
Syntax idle-payload-fill pattern pattern
no idle-payload-fill
idle-payload-fill {all-ones}
Context config>port>tdm>ds1>channel-group
config>port>tdm>e1>channel-group
7750 SR Interface Configuration Guide
g751 and cannot be changed.
g832 and cannot be changed.
Interface Configuration
Page 491