Alcatel-Lucent 7750 Configuration Manual page 410

Interfaces
degrades or signal failure threshold. The analysis is based solely on the information receive form the peer.
The analysis is performed on all event TLVs contained in the Event Notification OAMPDU without regard
for support of a specific error counters or local configuration of any thresholds. In the case of symbol errors
only, a threshold below the error rate can be used to return the port to service.
Default event-notification local-port-action log-only
Parameters local-port-action — Defines whether or not the local port will be affected when the Event Notification
OAM PDU is received from a peer based on the threshold computation for the included TLVs.
log-only — Keyword that prevents the port from being affected when the local peer receives a Event Notifi-
cation OAM PDU. The event will be logged but the port will remain operational.
out-of-service — Keyword that causes the port to enter a non-operation down state with a port state of link
up. The error will be logged upon reception of Event Notification. The port will not be available to ser-
vice data but will continue to carry Link OAM traffic to ensure the link is monitored. All this assumes
the error threshold exceeds the error rate in the TLV.
link-fault
Syntax link-fault local-port-action {log-only | out-of-service}
Context config>port>ethernet>efm-oam>peer-rdi-rx
Description This command defines how to react to the reception of a link faul flag set in the informational PDU from a
peer.
Default link-fault local-port-action out-of-service
Parameters local-port-action — Defines whether or not the local port will be affected when a link fault is received from
a peer.
log-only — Keyword that prevents the port from being affected when the local peer receives a link fault.
The dying gasp will be logged but the port will remain operational.
out-of-service — Keyword that causes the port to enter a non-operation down state with a port state of link
up. The error will be logged upon reception of link fault event. The port will not be available to service
data but will continue to carry Link OAM traffic to ensure the link is monitored.
transmit-interval
Syntax [no] transmit-interval interval [multiplier multiplier]
Context config>port>ethernet>efm-oam
Description This command configures the transmit interval of OAM PDUs.
Default transmit-interval 10 multiplier 5
Parameters interval — Specifies the transmit interval.
Values
Page 410
1 — 600 (in 100 milliseconds)
7750 SR Interface Configuration Guide