Alcatel-Lucent 7750 Configuration Manual page 519

Description This command configures the behavior for the eth-tunnel if the number of operational members is equal to
or below a threshold level
Parameters
num-paths — Specifies the threshold for the Ethernet Tunnel group.
Values
protection-type
Syntax protection-type {g8031-1to1 | loadsharing}
Context config>eth-tunnel
Description This command configures the model used for determining which members are actively receiving and trans-
mitting data.
The no form of the command reverts the default.
Default
no path-threshold
Parameters
g8031-1to1 — As per G.8031 spec, only two members are allowed, and only one of them can be active at
one point in time.
loadsharing — Multiple members can be active at one point in time.
revert-time
Syntax revert-time time
no revert-time
Context config>eth-tunnel
Description This command configure how long to wait before switching back to the primary path after it has been
restored to Ethernet tunnel.
The no form of this command sets the revert-time to the default value.
Default no revert-time – indicates non-revertive behavior.
Parameters time — Specifies the re-activation delay in seconds for the primary path.
Values
path
Syntax [no] path path-index
Context config>eth-tunnel
Description This command configures one of the two paths supported under the Ethernet tunnel. Although the values
indicate 1 — 8, only two paths, 1 and 2, are currently supported.
7750 SR Interface Configuration Guide
0 — 15
1 — 720 seconds
Interface Configuration
Page 519