Alcatel-Lucent 7750 Configuration Manual page 505

Description This command is used to specify the IPv4 or IPv6 address of the BFD destination.
The no form of the command removes this address from the configuration.
Default no remote-ip-address
Parameters ip-address — Specifies the IP address.
Values
transmit-interval
Syntax transmit-interval transmit-interval
no transmit-interval
Context config>lag>bfd>family
Description
This command specifies the transmit timer used for micro-BFD session over the associated LAG links.
The no form of the command removes the transmit timer from the configuration.
Default no transmit-interval
Parameters transmit-interval — Specifies the interval value, in milliseconds.
Values
Default
shutdown
Syntax shutdown
no shutdown
Context config>lag>bfd>family
Description This command disables micro BFD sessions for this address family.
The no form of the command re-enables micro BFD sessions for this address family.
Default no transmit-interval
dynamic-cost
Syntax [no] dynamic-cost
Context config>lag lag-id
7750 SR Interface Configuration Guide
ipv4-address: a.b.c.d
ipv6-address: x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 — FFFF]H
d: [0 — 255]D
10—100000
100 ms for CPM3 or later, 1 sec for all other
Interface Configuration
Page 505