Alcatel-Lucent 7750 Configuration Manual page 524

Interfaces
Description This command configures the test pattern for eth-test frames.
The no form of the command removes the values from the configuration.
Parameters all-zeros — Specifies to use all zeros in the test pattern.
all-ones — Specifies to use all ones in the test pattern.
crc-enable — Generates a CRC checksum.
Default
low-priority-defect
Syntax low-priority-defect {allDef | macRemErrXcon | remErrXcon | errXcon | xcon | noXcon}
Context config>eth-tunnel>path>eth-cfm>mep
Description This command specifies the lowest priority defect that is allowed to generate a fault alarm.
Default remErrXcon
Values
mac-address
Syntax mac-address mac-address
no mac-address
Context config>eth-tunnel>path>eth-cfm>mep
Description This command specifies the MAC address of the MEP.
The no form of this command reverts the MAC address of the MEP back to that of the port (if the MEP is on
a SAP) or the bridge (if the MEP is on a spoke SDP).
Parameters mac-address — Specifies the MAC address of the MEP.
Values
Page 524
all-zeros
allDef DefRDICCM, DefMACstatus, DefRemoteCCM, DefErrorCCM,
and DefXconCCM
macRemErrXconOnly DefMACstatus, DefRemoteCCM, DefErrorCCM, and
DefXconCCM
remErrXcon Only DefRemoteCCM, DefErrorCCM, and DefXconCCM
errXcon Only DefErrorCCM and DefXconCCM
xcon Only DefXconCCM; or
noXcon No defects DefXcon or lower are to be reported
6-byte unicast mac-address (xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx) of the MEP. Using
the all zeros address is equivalent to the no form of this command.
7750 SR Interface Configuration Guide