Alcatel-Lucent 7750 Configuration Manual page 309

no card-type
Context config>card
Description This mandatory command adds an IOM to the device configuration for the slot. The card type can be prepro-
visioned, meaning that the card does not need to be installed in the chassis.
A card must be provisioned before an MDAMCMor port can be configured.
A card can only be provisioned in a slot that is vacant, meaning no other card can be provisioned (config-
ured) for that particular slot. To reconfigure a slot position, use the no form of this command to remove the
current information.
A card can only be provisioned in a slot if the card type is allowed in the slot. An error message is generated
if an attempt is made to provision a card type that is not allowed.
If a card is inserted that does not match the configured card type for the slot, then a medium severity alarm is
raised. The alarm is cleared when the correct card type is installed or the configuration is modified.
A high severity alarm is raised if an administratively enabled card is removed from the chassis. The alarm is
cleared when the correct card type is installed or the configuration is modified. A low severity trap is issued
when a card is removed that is administratively disabled.
Because the IOM-3 integrated card does not have the capability to install separate MDAs, the configuration
of the MDA is automatic. This configuration only includes the default parameters such as default buffer pol-
icies. Commands to manage the MDA such as shutdown, named buffer pool, etc., remain in the MDA con-
figuration context.
An appropriate alarm is raised if a partial or complete card failure is detected. The alarm is cleared when the
error condition ceases.
The no form of this command removes the card from the configuration.
Default No cards are preconfigured for any slots.
Parameters card-type — The type of card to be configured and installed in that slot.
Values
fail-on-error
Syntax [no] fail-on-error
Context config>card
Description This command controls the behavior of the card when any one of a specific set of card level errors is encoun-
tered in the system. When the fail-on-error command is enabled, and any one (or more) of the specific
errors is detected, then the Operational State of the card is set to Failed. This Failed state will persist until the
clear card command is issued (reset) or the card is removed and re-inserted (re-seat). If the condition per-
sists after re-seating the card, then Alcatel-Lucent support should be contacted for further investigation.
7750 SR Interface Configuration Guide
iom-20g, iom2-20g, iom-20g-b, iom3-20g, iom3-40g, iom3-xp, imm48-1gb-sfp, imm48-
1gb-tx, imm4-10gb-xfp, imm5-10gb-xfp, imm8-10gb-xfp, imm12-10gb-SF+, imm1-
40gb-tun, imm3-40gb-qsfp, imm1-oc768-tun, imm1-100g-cfp, iom3-xp, iom4-eiom3-xp,
imm-2pac-fp3
Interface Configuration
Page 309