Alcatel-Lucent 7750 Configuration Manual page 668

Interfaces
A;ALA-1#
Port Frame Relay Output — The following table describes port Frame Relay output fields.
Mode
LMI Type
FR Interface
Status
Sample Output
A:ALA-49>config>port# show port 8/1/2 frame-relay
===============================================================================
Frame Relay Info for 8/1/2
===============================================================================
Mode
FR Interface Status
N391 DTE
N392 DTE
N393 DTE
T391 DTE
Tx Status Enquiry
Rx Status Messages
Status Message Timeouts : 0
Discarded Messages
===============================================================================
A:ALA-49>config>port#
OTU Output — The following table describes the OTU output fields.
Port Frame Relay Output Fields
OTU Status
Page 668
Label
Displays the mode of the interface. It can be set as Data terminal
equipment (dte) or Data circuit-terminating equipment (DCE).
Displays the LMI type.
Displays the status of the Frame Relay interface as determined by the
performance of the dlcmi. If no DLCMI is running, the Frame Relay
interface will stay in the running state indefinitely.
: dte
: fault
: 6
: 3
: 4
: 10
: 0
: 0
: 0
Label
Status of the OTU (Optical Transport Unit): enabled or disabled. When
OTU is enabled, and additional layer of framing encapsulates an MDA's
natively programmed mode of operation, 10-Gigabit Ethernet LAN or
WAN, adding SONET-Like Framing with FEC (Forward Error Correction).
When OTU is disabled, the MDA operates in a 10-Gigabit Ethernet LAN or
WAN as per Ethernet provisioning.
Description
LMI Type
N392 DCE
N393 DCE
T392 DCE
Rx Status Enquiry
Tx Status Messages
Status Enquiry Timeouts : 0
Inv. RxSeqNum Messages
Description
7750 SR Interface Configuration Guide
: itu
: 3
: 4
: 15
: 0
: 0
: 0