Alcatel-Lucent 7750 Configuration Manual page 760

Interfaces
request
Syntax request aps-id {protect | working}
Context tools>perform
tools>dump>aps
Description This command requests a manual switch to protection or working circuit.
Parameters aps-id — This option clears a specific APS on un-bundled SONET/SDH ports.
protect — This command requests a manual switch to a port that is acting as the protection circuit for the
APS group.
working — This command requests a manual switch to a port that is acting as the working circuit for this
APS group.
eth-tunnel
Syntax eth-tunnel tunnel-index [clear]
Context tools>dump
Description
This command displays Ethernet tunnel information.
Sample Output
*A:PE-E# tools dump eth-tunnel 1
TunnelId 1 (Up/Up), Port eth-tunnel-1 (Up/Up): type g8031-1to1
NumMems 2/2, Up/Dn 0/0, active 0x1, present 0x3 baseMemPort 1/1/2
memId 1 (P), port 1/1/2 (Up), tag 1.0(Up) status (Up/Up)
ccCnt-sf/ok 1/1 idx 0 tunId 1
memId 2 (S), port 2/1/2 (Up), tag 1.0(Up) status (Up/Up)
ccCnt-sf/ok 0/0 idx 1 tunId 1
TunId = 1, state = Running, Active =
revert = 1, ReqState = NR-NULL, Pdu(Tx/Rx): 0x0f0000/0x0f0000
Defects =
Running Timers = PduReTx
Work MemId = 1 (1/1/2:1.0), state = Ok, cc = 000 00:16:23.510U
Protect MemId = 2 (2/1/2:1.0), state = Ok, cc = 000 00:09:47.560U
DbgCnts: swoEv = 2, wMemSts = 2, pMemSts =
Seq
===
000
001
002
003
004
Page 760
ActiveCnt = 4, ActiveSeconds = 791
ActiveCnt = 3, ActiveSeconds = 308
rxPdu (valid/Invalid) = 4/0, wSfClr = 1, pSfClr = 0, wtrExp =
cm = 0, cmClr = 0, pm = 0, pmClr = 0, nr = 0, nrClr = 0
Event TxPdu
======== ============
wMemSts 0xbf0101 wSF
RxPdu 0xbf0101 wSF
RxPdu 0xbf0101 wSF
RxPdu 0xbf0101 wSF
wSFClr 0x5f0101 WTR
Work, Now = 000 00:16:48.140
0
RxPdu Dir
============ =====
0x0f0000 NR Tx-->
0x0f0101 NR Rx<--
0xbf0101 wSF Rx<--
0x0f0101 NR Rx<--
0x0f0101 NR Tx-->
7750 SR Interface Configuration Guide
1
Act Time
==== ================
Prot 000 00:16:12.450
Prot 000 00:16:12.450
Prot 000 00:16:12.480
Prot 000 00:16:24.890
Prot 000 00:16:25.030