Alcatel-Lucent 7750 Configuration Manual page 529

ccm-tlv-ignore
Syntax ccm-tlv-ignore [port-status] [interface-status]
no ccm-tlv-ignore
Context config>port>ethernet>eth-cfm>mep
config>lag>eth-cfm>mep
Description This command allows the receiving MEP to ignore the specified TLVs in CCM PDU. Ignored TLVs will be
reported as absent and will have no impact on the MEP state machine.
The no form of the command causes the receiving MEP will process all recognized TLVs in the CCM PDU.
Parameters port-status — Ignore the port status TLV on reception.
interface-status — ignore the interface status TLV on reception.
collect-lmm-stats
Syntax collect-lmm-stats
[no] collect-lmm-stats
Context config>port>ethernet>eth-cfm>mep
config>router>if>eth-cfm>mep
config>lag>eth-cfm>mep
Description This command enables the collection of statistics on the facility MEPs. This command is an object under
the Facility MEP. This is at a different level of the hierarchy than collection of lmm statistics for service
SAPs and MPLS SDP Bindings. The show mep command can be used to determine is the Facility MEP is
collecting stats.
The no form of the command disables and deletes the counters for this SAP, Binding or facility.
Default
no collect-lmm-stats
eth-test-enable
Syntax [no] eth-test-enable
Context config>port>ethernet>eth-cfm>mep
config>lag>eth-cfm>mep
config>router>if>eth-cfm>mep
Description For this test to work, operators need to configure ETH-test parameters on both sender and receiver nodes.
The ETH-test then can be done using the following OAM commands:
oam eth-cfm eth-test mac-address mep mep-id domain md-index association ma-index [priority priority]
[data-length data-length]
The no form of the command disables eth-test capabilities.
7750 SR Interface Configuration Guide
Interface Configuration
Page 529