Alcatel-Lucent 7750 Configuration Manual page 509

The no form of this command disables LACP message transmission. This command should be disabled for
compatibility when using active/standby groups. This forces a timeout of the standby links by the peer. Use
the no form if the peer does not implement the correct behavior regarding the lacp sync bit.
Default lacp-xmit-stdby
link-map-profile
Syntax link-map-profile link-map-profile-id [create]
no link-map-profile link-map-profile-id
Context config>lag
Description This command creates the link map profile that can to control which LAG ports are to be used on egress or
enables the configuration context for previously created link map profile.
The no form of this command, deletes the specified link map profile.
Default Link-map-profiles are not created by default.
Parameters link-map-profile-id — An integer from 1 to 64 that defines a unique lag link map profile on this LAG.
link
Syntax link port-id {primary|secondary}
no primary-link
Context config>lag>link>map>profile
Description This command designates one of the configured ports of the LAG to be used on egress as either a primary or
secondary link (based on the option selected) by all SAPs/network interfaces that use this LAG link map
profile.
The no form of this command deletes the link from this LAG link mapping profile. A port must be deleted
from all lag link profiles if it is to be deleted from the LAG.
Default Links are part of a profile.
Notes When a link gets added/deleted, all SAPs/network interfaces that use this link-map-profile may be re-hashed
if required.
Parameters port-id — A physical port Id in the slot/mda/port format that is an existing member of this LAG.
primary — Designates one of the configured ports of the LAG to be used on egress as a primary link by
SAPs/network interfaces that use this LAG link map profile.
secondary — Designates one of the configured ports of the LAG to be used on egress as a secondary link by
SAPs/network interfaces that use this LAG link map profile.
7750 SR Interface Configuration Guide
Interface Configuration
Page 509