Alcatel-Lucent 7750 Configuration Manual page 441

Context config>port>multilink-bundle>mlfr>frame-relay
Description This command configures the DCE/DTE mode of the Frame Relay interface.
Parameters dce — Enables the DCE mode.
dte — Enables the DTE mode.
bidir — Enables the bidirectional mode for LMI types ANSI and ITU.
n391dte
Syntax n391dte intervals
no n391dte
Context config>port>multilink-bundle>mlfr>frame-relay
Description This command confgures the number of DTE full status polling intervals for the LMI.
Parameters ntervals — The number of exchanges to be done before requesting a full-status report. A value of 1 speci-
fies to receive full-status messages only.
Values
n392dce
Syntax n392dce threshold
no n392dce
Context config>port>multilink-bundle>mlfr>frame-relay
Description
This command configures the DCE error threshold for the LMI.
Default
3
Parameters threshold — Specify the number of errors that will place the bundle in an operationally down state.
Values
7750 SR Interface Configuration Guide
1 — 255
1 — 10
Interface Configuration
Page 441