Alcatel-Lucent 7750 Configuration Manual page 517

Context config>eth-tunnel
Description This command configures eth-tunnel dampening timers.
member
Syntax member down time
no member
Context config>eth-tunnel>hold-time
Description
A default MAC address is assigned by the system from the chassis MAC address pool.This command speci-
fies the timer, which controls the delay between detecting that member path is down and reporting it to the
G.8031 protection module. If a non-zero value is configured, the CPM will wait for the time specified in the
value parameter before reporting it to the G.8031 protection module. Note that this parameter applies only to
member path CCM. It does NOT apply to the member port link state. To damp member port link state tran-
sitions, use hold-time parameter from the physical member port.
The no form of this command sets the hold-time to the default value.
Default
no member - the fault will be reported immediately to the protection module.
Parameters value — Specifies the hold-time for reporting the failure.
Values
lag-emulation
Syntax lag-emulation
Context config>eth-tunnel
Description This command configures eth-tunnel loadsharing parameters.
access
Syntax access
Context config>eth-tunnel>lag-emulation
Description This command configures eth-tunnel loadsharing access parameters
adapt-qos
Syntax adapt-qos {distribute | link | port-fair}
no adapt-qos
7750 SR Interface Configuration Guide
1-1000 centiseconds
Interface Configuration
Page 517