Alcatel-Lucent 7750 Configuration Manual page 349

mismatch-reaction
Syntax mismatch-reaction {none | squelch-rx}
Context config>port>otu>sm-tti
Description
This command allows the user to configure the consequent action to a sm-tti mismatch.
Default None
Parameters none — The received traffic is passed through.
squelch-rx — The received traffic is blocked.
pm-tti
Syntax pm-tti
Context config>port>otu
Description This command enables the context to configure path monitoring trail trace identifier parameters.
tx
Syntax tx auto-generated
tx bytes bytes [bytes...(up to 64 max)]
tx string identifier
tx auto-generated | string identifier | bytes byte1 [byte2...(up to 64 bytes)]}
no tx
Context config>port>otu>pm-tti>tx
Description This command enables the user to configure the transmit (tx) trail trace identifier (TTI) for path monitoring
(PM) in the ODU overhead. This identifier can be a string or a non-printable sequence of bytes. The length
of the string or sequence of bytes cannot exceed 64 bytes.
The no form of the command reverts to the default TTI.
Default Auto-generated in the format of nodename:iomnum/mdanum/portnum/dwdmchan
The auto-generated value has five sections:
•
•
•
•
•
Parameters
auto-generated — Specifies to use the system generated (default) TTI.
7750 SR Interface Configuration Guide
Nodename — The first section is the name of the node.
iomnum — The second section contains the IOM slot number.
mdanum — The third section contains the MDA slot number.
portnum — The fourth section contains the port number.
dwdmchan — The fifth section contains the DWDM channel number (see Table 32, DWDM
Channel Numbers, on page 334).
Interface Configuration
Page 349