Alcatel-Lucent 7750 Configuration Manual page 367

config>port>tdm>ds3
config>port>tdm>e1>channel-group
config>port>tdm>e3
Description This command enables access to the context to configure the LCP operational parameters for a SONET/
SDH PoS link, a DS--3/E-3 port or channel, a DS-1/E-1 channel or a DS-0 channel.
Default no ppp
compress
Syntax compress {acfc [pfc] | pfc [acfc]}
no compress
Context config>port>tdm>ds1>channel-group>ppp
config>port>tdm>e1>channel-group>ppp
Description This command enables and disables Protocol Field Compression (PFC) per RFC 1661, The Point-to-Point
Protocol (PPP), Section 6.5 and Address and Control Field Compression (ACFC) as per Section 6.6.
This command is only supported on DS-1 and E-1 channel groups on ASAP MDAs.
The no form of the command disables the header compression.
Default
no compress
Parameters
acfc — Specifies address and control field compression.
pfc — specifies protocol field compression.
ber-sf-link-down
Syntax [no] ber-sf-link-down
Context config>port>tdm>ds1>channel-group>ppp
config>port>tdm>e1>channel-group>ppp
Description
This command enables the port down on BER-SF alarm. When enabled, the link will be placed out of ser-
vice once ber-sf is detected.
The no form of the command reverts to normal operation where the link remains in-service when ber-sf is
encountered.
Default no ber-sf-link-down
report-alarm
Syntax [no] report-alarm [ais] [los] [oof] [rai] [looped]
Context config>port>tdm> ds3
7750 SR Interface Configuration Guide
Interface Configuration
Page 367