Alcatel-Lucent 7750 Configuration Manual page 380

Interfaces
When the queue group is created on a LAG (Link Aggregation Group), it must be created on the primary
port member. The primary port member is the port with the lowest port ID based on the slot, MDA position
and port number on the MDA. A queue group created on the primary LAG port will be automatically created
on all other port members. If a new port is being added to a LAG with an existing queue group, the queue
group must first be created on the port prior to adding the port to the LAG. If the LAG queue group has
queue overrides, the queue overrides must also be defined on the port queue group prior to adding the port to
the LAG.
A port queue group cannot be removed from the port when a forwarding class is currently redirected to the
group. All forwarding class redirections must first be removed prior to removing the queue group.
Default none
Parameters group-name — The group-name parameter is required when executing the port queue-group command. The
specified group-name must exist as an ingress or egress queue group template depending on the ingress
or egress context of the port queue group. Only a single queue group may be created on an ingress port.
Multiple queue groups may be created on an egress port.
instance-id — specifies the identification of a specific instance of the egress queue-group. This parameter is
only valid for egress access port queue groups.
Values
create — Keyword used to associate the queue group. The create keyword requirement can be enabled/ dis-
abled in the environment>create context.
egress
Syntax egress
Context config>port>ethernet
This command configures Ethernet egress port parameters.
ingress
Syntax ingress
Context config>port>ethernet>access
Description
This command configures Ethernet access ingress port parameters.
queue-group
Syntax queue-group queue-group-name [instance instance-id] [create]
no queue-group queue-group-name
Context config>port>ethernet>access>egr
config>port>ethernet>access>ing
Page 380
1 — 40960
7750 SR Interface Configuration Guide