Alcatel-Lucent 7750 Configuration Manual page 430

Interfaces
LLDP Port Commands
lldp
Syntax lldp
Context config>port>ethernet
Description This command enables the context to configure Link Layer Discovery Protocol (LLDP) parameters on the
specified port.
dest-mac
Syntax dest-mac {bridge-mac}
Context config>port>ethernet>lldp
Description This command configures destination MAC address parameters.
Parameters bridge-mac — Specifies destination bridge MAC type to use by LLDP.
Values
admin-status
Syntax admin-status {rx | tx | tx-rx | disabled}
Context config>port>ethernet>lldp>dstmac
Description This command configures LLDP transmission/reception frame handling.
Parameters rx — Specifies the LLDP agent will receive, but will not transmit LLDP frames on this port.
tx — Specifies that the LLDP agent will transmit LLDP frames on this port and will not store any
information about the remote systems connected.
tx-rx — Specifies that the LLDP agent transmitw and receives LLDP frames on this port.
disabled — Specifies that the LLDP agent does not transmit or receive LLDP frames on this port. If there is
remote systems information which is received on this port and stored in other tables, before the port's
admin status becomes disabled, then the information will naturally age out.
Page 430
nearest-bridge — Specifies to use the nearest bridge.
nearest-non-tpmr — Specifies to use the nearest non-Two-Port MAC Relay (TPMR) .
nearest-customer — Specifies to use the nearest customer.
7750 SR Interface Configuration Guide