Alcatel-Lucent 7750 Configuration Manual page 153

===============================================================================
Ethernet Interface
===============================================================================
Description
Interface
Link-level
Admin State
Oper State
Reason Down
Physical Link
Single Fiber Mode
IfIndex
Last State Change
Last Cleared Time
Phys State Chng Cnt: 1
Configured Mode
Dot1Q Ethertype
PBB Ethertype
Ing. Pool % Rate
Ing. Pool Policy
Egr. Pool Policy
Net. Egr. Queue Pol: default
Egr. Sched. Pol
Auto-negotiate
Oper Phy-tx-clock
Accounting Policy
Acct Plcy Eth Phys : None
Egress Rate
Load-balance-algo
Down-when-looped
Loop Detected
Use Broadcast Addr : False
Sync. Status Msg.
Tx DUS/DNU
SSM Code Type
Down On Int. Error : Disabled
CRC Mon SD Thresh
CRC Mon SF Thresh
Configured Address : d8:ef:01:01:00:03
Hardware Address
The operator also has the opportunity to decouple the efm-oam protocol from the port state and
operational state. In cases where an operator wants to remove the protocol, monitor the protocol
only, migrate, or make changes the ignore-efm-state can be configured in the
port>ethernet>efm-oam context. When the ignore-efm-state command is configured on a port
the protocol continues as normal. However, ANY failure in the protocol state machine (discovery,
configuration, time-out, loops, etc.) will not impact the port on which the protocol is active and the
optional ignore command is configured. There will only be a protocol warning message if there
are issues with the protocol. The default behavior when this optional command is not configured
7750 SR Interface Configuration Guide
: 10/100/Gig Ethernet SFP
: 1/1/3
: Ethernet
: up
: down
: efmOamDown
: Yes
: No
: 35749888
: 12/18/2012 15:58:29
: N/A
: access
: 0x8100
: 0x88e7
: 100
: n/a
: n/a
: n/a
: true
: not-applicable
: None
: Default
: Default
: Disabled
: False
: Disabled
: Disabled
: sdh
: Disabled
: Disabled
: d8:ef:01:01:00:03
Interface Configuration
Oper Speed : N/A
Config Speed : 1 Gbps
Oper Duplex : N/A
Config Duplex : full
MTU : 1522
Min Frame Length : 64 Bytes
Hold time up : 0 seconds
Hold time down : 0 seconds
DDM Events : Enabled
Encap Type : QinQ
QinQ Ethertype : 0x8100
Egr. Pool % Rate : 100
MDI/MDX : unknown
Collect-stats : Disabled
Collect Eth Phys : Disabled
Ingress Rate : Default
LACP Tunnel : Disabled
Keep-alive : 10
Retry : 120
Rx Quality Level : N/A
Tx Quality Level : N/A
CRC Mon Window : 10 seconds
Page 153