Alcatel-Lucent 7750 Configuration Manual page 523

ccm-enable
Syntax [no] ccm-enable
Context config>eth-tunnel>path>eth-cfm>mep
Description
This command enables the generation of CCM messages.
The no form of the command disables the generation of CCM messages.
ccm-ltm-priority
Syntax ccm-ltm-priority priority
no ccm-ltm-priority
Context config>eth-tunnel>path>eth-cfm>mep
Description This command specifies the priority value for CCMs and LTMs transmitted by the MEP.
The no form of the command removes the priority value from the configuration.
Default
The highest priority on the bridge-port.
Parameters priority — Specifies the priority of CCM and LTM messages.
Values
eth-test-enable
Syntax [no] eth-test-enable
Context config>eth-tunnel>path>eth-cfm>mep
Description This command enables eth-test functionality on MEP. For this test to work, operators need to configure
ETH-test parameters on both sender and receiver nodes. The ETH-test then can be done using the following
OAM commands:
oam eth-cfm eth-test mac-address mep mep-id domain md-index association ma-index [priority priority]
[data-length data-length]
A check is done for both the provisioning and test to ensure the MEP is an Y.1731 MEP (MEP provisioned
with domain format none, association format icc-based). If not, the operation fails. An error message in the
CLI and SNMP will indicate the problem.
test-pattern
Syntax test-pattern {all-zeros | all-ones} [crc-enable]
no test-pattern
Context config>eth-tunnel>path>eth-cfm>mep>eth-test-enable
7750 SR Interface Configuration Guide
0 — 7
Interface Configuration
Page 523