Alcatel-Lucent 7750 Configuration Manual page 408

Interfaces
local-port-action
Syntax local-port-action {log-only | out-of-service}
Context config>port>ethernet>efm-oam>link-monitoring>local-sf-action
Description
The configuration parameters that define if and how the local port will be affected when the local signal fail-
ure threshold (sf-threshold) has been reached within the configured window.
Interactions: The signal failure threshold will trigger these actions.
Default local-port-action out-of-service
Parameters log-only — Keyword that prevents the port from being affected when the configured signal failure threshold
is reach within the window. The event will be logged but the port will remain operational.
out-of-service — Keyword that causes the port to enter a non-operation down state with a port state of link
up. The error will be logged when the configured signal failure threshold (sf-threshold)is reached
within the window. The port will not be available to service data but will continue to carry Link OAM
traffic to ensure the link is monitored.
mode
Syntax mode {active | passive}
Context config>port>ethernet>efm-oam
Description This command configures the mode of OAM operation for this Ethernet port. These two modes differ in that
active mode causes the port to continually send out efm-oam info PDUs while passive mode waits for the
peer to initiate the negotiation process. A passive mode port cannot initiate monitoring activites (such as
loopback) with the peer.
Default active
Parameters active — Provides capability to initiate negotiation and monitoring activities.
passive — Relies on peer to initiate negotiation and monitoring activities.
peer-rdi-rx
Syntax peer-rdi-rx
Context config>port>ethernet>efm-oam
Description This container allows an action to be configured for the various event conditions that can be received from a
peer under the context of the EFM OAM protocol.
Page 408 7750 SR Interface Configuration Guide