Alcatel-Lucent 7750 Configuration Manual page 580

Interfaces
Default
primary-override
Syntax primary-override
Context config>card>mda>ingress>mcast-mgmt
Description This command enables the context to configure MDA ingress multicast path-limit overrides.
The path override CLI nodes are not supported on IOM-3.
secondary-override
Syntax secondary-override
Context config>card>mda>ingress>mcast-mgmt
Description This command enables the context to configure MDA ingress multicast path-limit overrides.
The path override CLI nodes are not supported on IOM-3.
ancillary-override
Syntax ancillary-override
Context config>card>mda>ingress>mcast-mgmt
Description This command enables the context to configure MDA ingress multicast path-limit overrides.
path-limit
Syntax path-limit megabits-per-second
no path-limit
Context config>card>mda>ingress>mcast-mgmt>primary-override
config>card>mda>ingress>mcast-mgmt>secondary-override
config>card>mda>ingress>mcast-mgmt>ancillary-override
Description The path-limit command is used to override the path limits contained in the bandwidth policy associated
with the MDA. The path limits are used to give the upper limit that multicast channels may use on each path.
The path-limit commands are not supported on IOM-3.
The no form of the command removes a path limit override from an ingress multicast path and restore the
path limit defined in the bandwidth policy associated with the MDA.
Parameters megabits-per-second — The megabits-per-second parameter is required when executing the path-limit com-
Page 580
default
7750 SR Interface Configuration Guide