Alcatel-Lucent 7750 Configuration Manual page 390

Interfaces
exp-secondary-shaper
Syntax exp-secondary-shaper {default | secondary-shaper-name} create
no exp-secondary-shaper secondary-shaper-name
Context config>port>ethernet>egress
Description This command configures the Ethernet egress expanded secondary shaper on this port.
Parameters secondary-shaper-name — Specifies the secondary shaper name to apply to this port.
default — Specifies the default secondary shaper to apply to this port.
create — Creates a new secondary shaper for this port.
rate
Syntax rate {max | kilobits-per-second}
no rate
Context config>port>ethernet>egress>exp-secondary-shaper
Description This command is used to configure the shaper's metering and optional profiling rates. The metering rate is
used by the system to configure the shaper's PIR leaky bucket's decrement rat. The decrement function emp-
ties the bucket while packets applied to the bucket attempt to fill it based on the each packets size. If the
bucket fills faster than how much is decremented per packet, the bucket's depth eventually reaches it's vio-
late (PIR) threshold.
The no form of this command is used to restore the default metering and profiling rate to a policer.
Parameters {max | kilobits-per-second} — Specifying the keyword max or an explicit kilobits-per-second parameter
directly following the rate command is required and identifies the policer's metering rate for the PIR
leaky bucket. When the shaper is first created, the metering rate defaults to max. The kilobits-per-sec-
ond value must be expressed as an integer and defines the rate in kilobits-per-second. The integer value
is multiplied by 1,000 to derive the actual rate in bits-per-second.
Values
class
Syntax class class-number rate {kilobits-per-second | max} [monitor-threshold size-in-kilobytes]
no class
Context config>port>ethernet>egress>exp-secondary-shaper
Description This command assigns the low burst maximum class to associate with the Ethernet egress expanded
secondary shaper.
The no form of the command returns the class id for the Ethernet egress expanded secondary shaper to the
default value.
Page 390
1—10000000 kbps
7750 SR Interface Configuration Guide