Led And Beeper Indications; User Indications For Pd9600 - Datalogic PowerScan Series Product Reference Manual

TECHNICAL SPECIFICATIONS

LED AND BEEPER INDICATIONS

The reader's beeper sounds and its LED illuminates to indicate various functions or
errors on the reader. An optional "Green Spot" also performs useful functions. The fol-
lowing tables list these indications. One exception to the behaviors listed in the tables is
that the reader's functions are programmable, and so may or may not be turned on. For
example, certain indications such as the power-up beep can be disabled using program-
ming bar code labels.
Table 33LED and Beeper Indications
INDICATION
Power-up
Good Read
ROM Failure
Limited Scanning
Label Read
Reader Disabled
Image Capture
Double TAP

USER INDICATIONS FOR PD9600

Table 34 User Indications for PD9600
STATUS
Power-up
USB Enumeration Phase
USB Suspend
Idle
While Reading
Decode Done
Reader Disabled (POS)
Communication with host not
established
Firmware Upgrade
Host Download
Enter Service Mode
Label Programming
a. "msec" stands for milliseconds, equivalent to 1/1000th of a second
352
POWERSCAN™ PD/PM/PBT9600
LED
Upper LED flashes/blinks on power-up,
however, this may be too rapid to view. With
a USB interface, the LED blinks until enu-
meration with the host is completed.
LED behavior for this indication is configu-
rable via the feature "Good Read: When to
Indicate".
The Green spot turns on for a configurable time.
Flashes
N/A
The LED blinks continuously 100mS on / 900mS off
Blue light
The scanner turns on the LED for a few sec-
onds indicating the state of the battery.
Green: completely charged.
Orange: half charge.
Red: low battery.
3GL AND GOOD READ LED
OFF
a
250 msec ON
Depends on Power Cable and specific configurations
OFF
OFF
Solid ON
Programmable Duration (1 s default)
100 msec ON
250 msec ON
250 msec ON
No Effect
No Effect
Reader beeps four times at highest fre-
quency and volume upon power-up.
The reader will beep once at current fre-
quency, volume, mono/bi-tonal setting
and duration upon a successful label scan.
Reader sounds 4 long beeps.
Reader 'chirps' six times at the highest
frequency and current volume.
N/A
N/A
N/A
↔
250 msec OFF
↔
900 msec OFF
↔
250 msec OFF
↔
250 msec OFF
BEEPER
BUZZER
Rising Beeps' Sequence
OFF
OFF
OFF
OFF
Single Beep
OFF
OFF
OFF
Beeps' Sequence
Beep