Code 11 Length Control; Code 11 Set Length 1 - Datalogic Cobalto CO5330 Product Reference Manual

Code 11

Code 11 Length Control

This feature specifies either variable length decoding or fixed length decoding for the Code 11
symbology.
Variable Length —
Fixed Length —
DEFAULT
$CC1LC01
Code 11 Length Control = Fixed Length

Code 11 Set Length 1

This feature specifies one of the bar code lengths for
minimum label length if in
Mode. Length includes the bar code's check and data characters.
The length can be set from 2 to 50 characters. See
detailed programming instructions.
Select Code 11 Set Length 1 Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
Product Reference Guide
For variable length decoding, a minimum and maximum length may be set.
For fixed length decoding, two different lengths may be set.

Variable Length
$CC1L1
DEFAULT
Code 11 Length Control = Variable Length
Code 11 Length Control
Mode, or the first fixed length if in
"Set Length 1"
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by dig-
its from the Alphanumeric characters in
Keypad
representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
04 = Length 1 is 4 Characters
Enter/Exit Programming Mode

$CC1LC00
. Length 1 is the
Fixed Length
on page 239 for more
Appendix D,
~
CANCEL
163