Example For Configuring The Configuration Synchronization Function For An Hgmp Cluster - Huawei Quidway S5700 Series Configuration Manual - Network Management

Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management
l
3.6.9 Example for Configuring the Configuration Synchronization
Function for an HGMP Cluster
Networking Requirements
As shown in
is the administrator switch of the cluster and other switches are member switches. The member
ID of Member-2 is 2 and the member ID of Member-3 is 3.
To synchronize the configuration files of all member switches to the FTP server as required, you
can configure the configuration synchronization function for the HGMP cluster.
Issue 01 (2011-10-26)
#
return
Configuration file of Member-3.
#
sysname Member-3
#
vlan batch 10
#
cluster enable
ntdp enable
ntdp hop 3
ntdp timer 10
ndp enable
#
interface Vlanif10
#
interface GigabitEthernet0/0/1
port link-type trunk
port trunk allow-pass vlan 10
ntdp enable
ndp enable
#
cluster
mngvlanid 10
administrator-address 0001-0001-0001 name HUAWEI
#
return
Figure 3-11, all the Layer 2 switches belong to the same cluster. Administrator-1
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 HGMP Configuration
188