Huawei Quidway S5700 Series Configuration Manual - Network Management page 376

Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management
Figure 6-16 Networking diagram for configuring the PWE3 Ping test on the single-hop PW
PE-A
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Procedure
Step 1 Configure a dynamic single-hop PW.
Configure a dynamic single-hop PW on the MPLS backbone network.
For the detailed configuration procedure, see "PWE3 Configuration" in the Quidway S5700
Series Ethernet Switches Configuration Guide - VPN.
Step 2 Configure a PWE3 Ping test of the single-hop PW.
# Configure PE-A.
<PE-A> system-view
[PE-A] nqa test-instance test pwe3ping
Issue 01 (2011-10-26)
Loopback0
192.2.2.2/32
GE2/0/0
VLANIF120
10.1.1.1/24
VLANIF120
GE1/0/0
10.1.1.2/24
VLANIF110
GE1/0/0
VLANIF110
100.1.1.1/24
CE-A
Run the IGP protocol on the backbone network to make the routes between Switches on
the backbone network reachable.
Configure the basic MPLS functions on the backbone network and set up an LSP tunnel.
Set up the MPLS LDP peer relation between the two PE devices on the two ends of the
PW.
Create an MPLS L2VC connection between the two PE devices.
Configure a PWE3 Ping test on the single-hop PW on PE-A.
L2VC IDs of the two ends of the PW, which must be the same
MPLS LSR-IDs of the PE and P devices
IP address of the remote peer
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
MPLS Backbone
Loopback0
192.4.4.4/32
GE2/0/0
GE1/0/0
VLANIF130
P
10.2.2.1/24
PW
6 NQA Configuration
Loopback0
192.3.3.3/32
GE2/0/0
VLANIF130
10.2.2.2/24
GE1/0/0
PE-B
VLANIF140
GE1/0/0
VLANIF140
100.1.1.2/24
CE-B
365